52
Start-up
• Place the dimming actuator onto the DIN rail (
see
fig. 3
). Make sure that you can read the letters on
the device and display and that the connecting
terminals of channel 1 and 3 are at the top.
• Make sure that the catch spring
(G)
engages
properly and that the device is securely seated on
the rail (
see figure 4
).
• Wire the device according to the connecting
diagrams in
figure 6 or 7
.
• Connect the phase conductor to the
corresponding terminals
(F
and
H)
, the dimmed
phase (to the consumer) to terminal
(J)
as well
as the neutral conductor to the terminals
(I)
(
see
figure 6+7
). You can connect any types of phase
conductors (L1, L2, L3).
The self-supply of the dimming actuator as well
as the supply of the third channel are established
via terminals
L/3L
and
N/3N
.
The connections of the neutral conductor
(I)
are
not connected to each other within the device.
Therefore, all three terminals (1N, 2N, N/3N) must
be connected to the neutral conductor. If three
lamp circuits are fused via separate residual-
current circuit breakers, separate neutral
conductors must be connected as well.
Summary of Contents for HmIP-DRDI3
