Installation instructions
Connection of the inlet hose
Refer to Section on Water Supply Requirements before connecting water
inlet hoses.
Faucet:
The faucet must be with G3/4" standard screw
thread. If not , it is impossible to connect the
inlet hose properly.
I. About faucet
1. If you just have one water supply line (cold or hot water), connect the
inlet hose to the cold water connector in water mixing valve. (Do not
unscrew the lid of hot water connector in water mixing valve, otherwise
it will result in water leakage from the hot water valve during fill cycles.
IMPORTANT: At this situation you can not set wash temperature to
WARM/COLD or HOT/COLD.
II. About washing machine
Connect the other end of water inlet
hoses to the cold connector in water
mixing valve by turning the connecting
nut.
WATER
INLET HOSE
CONNECTING
NUT
COLD WATER
CONNECTOR
LID OF HOT WATER
CONNECTOR
RUBBER RING SEAL
WARNING:
Do not twist the inlet hose.
If water leakage, check the nut whether it is
filled with sealed rubber ring.
Connection of faucet:
Put rubber ring seal into the nut at one
elbow of inlet hose and fasten it to the
faucet as shown in the illustration.
Installation and connection of the Inlet hose
RUBBER RING
SEAL
Note:
The washing machine is to be connected to the water mains using new
hose-sets supplied with the appliance are to be used and old hose-sets
should not be re-used.
