Page 5 of 9
2 Components
3 Preparation
•
When ready to use the cooler, make sure that the power switch is set to OFF
and the unit is disconnected from the power point.
•
Ensure the rubber drain plug is fully inserted into the drain hole
(located underneath the appliance).
•
Pour clean cold water into the water box through the opening in
the side of the cooler. Fill until the level has reached the Maximum
mark. Do Not Fill with any liquid other than clean cold water. Do
Not add any additives to the water.
•
Located in the top rear of the appliance is an Ice Box. This can
be filled with ice blocks during use which will help cool the water.
As the ice melts, it can be topped up by pulling open the ice box
flap and refilling.
9
12
13
1
Control Panel
8
Handle
2
Left-Right Louver
9
Remote Control
3
Up-Down Louver
10 Mesh Filter
4
Front Body
11 Power Cord and Plug
5
Water Level Indicator
12 Ice Box Opening
6
Water Tank Opening
13 Drain Plug (underneath)
7
Castor Wheels
