10
warm but not hot. Warm lubricant will drain quickly and
more completely.
■
After the crankcase is completely drained, return the
pressure washer to an upright position.
■
Fill with lubricant following the instructions in Adding
Lubricant To The Engine earlier in this manual.
note:
Consult hazardous waste management guidelines
in your area for the proper way to dispose of used lubricant.
PuMP luBriCation
The pump on this product was lubricated with a sufficient
amount of high grade lubricant for the life of the unit
under normal operating conditions. Therefore, no further
lubrication is required.
storing tHe Pressure wasHer
Store the pressure washer with the petrol tank empty by
either draining the tank or running the pressure washer
until the petrol runs out. Allow 30 minutes of “cool down”
time before storing the machine. Never place the unit in
any position other than upright on its wheels.
Store in a dry, covered area where the weather can’t
damage it.
It is important to store this product in a frost-free area.
Always empty water from all hoses, the pump, and the
detergent bucket before storing.
note:
Use of a fuel stabilizer and pump saver will give
you better performance and increase the life of the
machine.
discharge fuel:
Drain the fuel tank completely. Stored fuel can go stale
in 30 days.
engine lubricant:
Drain the lubricant and replace with fresh, clean lubricant.
spark plug:
■
Disconnect spark plug wire and remove the spark
plug. Pour about a teaspoon of clean, air-cooled, four-
cycle lubricant through the spark plug hole into the
combustion chamber.
■
Leaving the spark plug out, pull the starter cord two or
three times to coat the inside of the cylinder wall.
■
Inspect the spark plug and clean or replace, as
necessary.
■
Reinstall the spark plug, but leave the spark plug wire
disconnected.
Air filter:
■
Clean the air filter.
Hoses and pump:
Flush the injection hose with clean water for 1-2 minutes.
Remove all hoses. Empty the pump by pulling on the
recoil starter about 6 times. This should remove most of
the liquid from the pump.
PreParing for use after storage
■
Pull the starter grip with rope three or four times to
clean lubricant from the combustion chamber.
■
Remove spark plug from the cylinder. Wipe lubricant
from the spark plug and return it to the cylinder.
■
Reconnect the spark plug wire.
■
Refuel the machine as described earlier in the
operator’s manual.
