2
■
Dangerous Environments.
To avoid falling, do not
use the product in damp or wet locations.
■
Controlling the Product.
During carburetor
adjustments, the cutting attachment may spin.
Therefore, you should wear protective equipment
and observe all safety instructions when adjusting
the carburetor. For products equipped with a clutch,
be sure the cutting attachment stops turning when the
engine idles. When the product is turned off, make
sure the cutting attachment has stopped before setting
down the product.
■
Use the Right Product.
Use the product for the
intended purpose only.
■
Save these instructions.
Refer to them frequently
and use them to instruct others who may use the
product. If you loan someone the product, loan them
these instructions also.
GENERAL SAFETY WARNINGS
WARNING
Read and understand all instructions. Failure to follow
all instructions may result in serious personal injury as
well as damage to the product.
■
Physical Condition of the Operator.
Do not operate
the product when tired, ill or under the influence of
alcohol, drugs or medication.
■
Clothing Requirements.
Always wear long, heavy
pants, boots and gloves. Do not wear loose clothing,
jewellery, short pants, sandals or go barefoot.
Secure hair so that it is above shoulder level to avoid
entanglement in moving parts.
■
Protective Accessories Requirements.
Wear eye
and hearing protection when operating the product.
Before use, inspect the condition of the trimmer.
Replace damaged parts. Check for fuel leaks. Make
sure all fasteners are in place and secure. Replace
cutting attachment parts that are cracked, chipped or
damaged in any way. Make sure the cutting attachment
is properly installed and securely fastened. Be sure
the cutting attachment shield is properly attached and
in the position recommended by the manufacturer.
Use only flexible, non-metallic line recommended by
the manufacturer. For example, never use wire or wire
rope, which can break off and become a dangerous
projectile.
■
Proper Stance. Keep firm footing and balance.
Do
not overreach. Keep the cutting attachment below
waist level. Keep all parts of your body away from the
rotating cutting attachment and hot surfaces.
■
Exhaust Gases.
Never start or run the product inside
a closed room or building. Breathing exhaust fumes
can cause illness or death.
■
Fueling.
Mix and pour fuel outdoors where there are
no sparks and flames. Slowly remove the fuel cap only
after stopping the engine. Do not smoke while fueling
or mixing fuel. Wipe spilled fuel from the product.
Move at least 30 ft. (9 m) away from the fueling source
and site before starting the engine.
■
Work Area.
Clear the work area to be cut before each
use. Remove all objects, such as rocks, broken glass,
nails, wire, or string, that can be thrown or become
entangled in the cutting attachment. Clear the area
from children, bystanders and pets. At a minimum,
keep all children, bystanders, and pets outside a 50
ft. (15 m) radius. Because there still may be a risk of
injury to bystanders from thrown objects, bystanders
should be encouraged to wear eye protection. If you
are approached while operating the product, stop the
engine and the cutting attachment.
Summary of Contents for HLT25CDSNC
Page 11: ......