6
3
The FCC Wants You to Know
This equipment has been tested and found to comply with the limits for a Class
B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed
to provide reasonable protection against harmful interference in a residential
installation. This equipment generates, uses and can radiate radio frequency energy
and, if not installed and used in accordance with the instructions, may cause harmful interference to
radio communications.
However, there is no guarantee that interference will not occur in a particular installation. If this
equipment does cause harmful interference to radio or television reception, which can be determined
by turning the equipment off and on, the user is encouraged to try to correct the interference by one or
more of the following measures:
•
Reorient or relocate the receiving antenna.
•
Increase the separation between the equipment and receiver.
•
Connect the equipment into an outlet on a circuit different from that to which the receiver is
connected.
•
Contact your local electronic store for help.
FCC Information
This device complies with Part 15 of the FCC Rules. Operation is subject to the following two
conditions:
(1) this device may not cause harmful interference, and
(2) this device must accept any interference received, including interference that may cause
undesired operation.
Warning:
Changes or modifications to this unit not expressly approved by the party responsible for
compliance could void the user’s authority to operate the equipment.
Parts Included with This System
1. 2.4 GHz Wireless color camera x2
2. 2.4 GHz Wireless receiver x1
3. 7.5V AC/DC Adaptor for the camera x2
4. 7.5V AC/DC Adaptor for the receiver x1
5. A/V Cable x1
6
Remote Control x1
7. Camera bracket x 2
System Installation
When installing the camera, check the reception of the receiver before final installation. Have
someone hold the camera in the area to be monitored. Have another person move the receiver to a
variety of locations throughout the house to check reception. If interference or other problems occur,
refer to the Troubleshooting Guide.
To install the system, follow these steps:
-
Select the same channel to be used on both the camera and receiver.
Channel selection on the camera
The camera can be set up in two different optional channels. To
set the channel, use a pointed object, e.g. a ballpoint pen, to select
the desired channel to position on CH1 or CH2. Only one channel
is activated on one camera.
Channel selection on the receiver
The receiver can receive up to two different channels. Detect the available signal and execute auto
scan function. You now have the possibility of selecting a certain channel or monitoring up to two
cameras in scan mode.
A. Single Channel Display
If only one camera is installed
Turn off then turn on the receiver, the receiver will scan the available channels and lock on a
specific camera either camera 1 or camera 2.
B. Two Channel Display
If more than one camera is installed and operate simultaneously
1. Turn off then turn on the receiver, the receiver will detect two channels, and enter into auto
scan mode (5 seconds interval between CH1 & CH2)
2. Select the channel you wish to watch; simply by pressing the channel selection button on
remote control/receiver for desired channel (1st, 2nd press).
3. For auto-scan channel selection with 3rd press to the channel selection button, all 2
channels: CH1, CH2 are displayed for Camera 1, Camera 2 on the TV/monitor at 5 sec
intervals repeatedly.
Notice:
1. The cameras are preset to CH1 and CH2 from factory.
2. While the system is in operation if either camera is not working properly, push scan button on
remote control or channel SEL on receiver to reset the system.
Press CH SEL once for
Channel 1, Camera 1
Receiver Set to
Channel 1
Press CH SEL twice for
Channel 2, Camera 2
Receiver Set to
Channel 2
Camera Set to
Channel 1
Camera Set to
Channel 2