5
Instructions for Use
1. Ensure that the unit is unplugged before filling with water. Fill with
warm water to the fill line located on the inside of the tub.
NOTE:
The footbath will not heat cold water. For a warm water
massage, fill unit with warm water.
Caution:
Do not fill water over the fill line.
2. Place the unit on a waterproof surface, or any surface that cannot
be damaged by splashing water.
3. Plug the unit into a 120 volt household outlet.
4. Sit down in a comfortable position. With the touch of your toe, press
the on/off button.
5. Select hydro jet massage, vibration massage, or both by pressing
the corresponding buttons on the control panel.
6. Manually massage your heels, arches, and toes by rubbing your
feet over the center massage node.
7. To empty: first, unplug the unit. Take the foot spa to the closest
drain and tip the unit allowing water to pour out along the drain
spout. DO NOT pour water over the control panel.
NOTE:
To reduce splashing due to different water displacements of
feet, raise or lower the water level of the footbath.
Maintenance
To Clean
Unplug the unit and allow it to cool before cleaning. Clean only with a
soft, damp cloth and mild cleansing agent.
• After cleaning, wipe surfaces with a dry cloth.
• Never use strong abrasives, detergents or cleansing agents.
• Periodically straighten cord if it becomes twisted.
To Store
Unplug the appliance from the outlet and allow to cool and dry.
• Store in its box or a clean, dry place.
• To avoid breakage, do not wrap the power cord around the unit.
• Do not hang the unit by the power cord.
Caution:
To avoid injury
and irreparable
damage, always
remain seated
when using this
foot massager.
Never stand on
or in the unit.
CAUTION: THIS
UNIT CAN ONLY
RUN WITH
WATER IN IT.
DO NOT USE
WITHOUT
WATER.
