6
7
Caution:
All servicing of
this fountain must
be performed by
authorized
HoMedics
service
personnel only.
Attention:
In order to get
best results,
please operate
pump completely
submerged
Maintenance
• To keep water clean:
Periodically change water and clean the product according to the
water condition. Keeping the water clean prevents the water from
becoming sticky and forming micro-organisms. We recommend
distilled water to prevent mineral build-up.
• To clean off hard water deposits on the base:
Use a mixture of vinegar and water to clean and remove any mineral
build-up on the base and pump.
• Keeping the water at an optimum level:
Add water periodically to keep water level at an optimum level and to
avoid shortening the life of the pump.
NOTE:
Never let the pump run
dry.
• Fountain Storage
Unplug the fountain from the electrical outlet, empty the water,
and store in a dry, cool place.
Troubleshooting
• If the pump fails to operate, check the following:
Check the circuit breaker, or try a different outlet to make sure the
pump is getting electrical power.
NOTE:
Always disconnect from
electrical outlet before handling the pump.
• If the pump gurgles, spews, or “burps”:
Check the water level to make sure the pump has
enough water to function.
• Obtaining a desired water level:
Check the water level daily the first week to measure the
rate of evaporation; refill with water as needed.
• If water is splashing outside the fountain:
Adjust the flow control valve to a lower setting on the pump.
5. Set the fountain top onto the base lining up the notch, so it sits level (Fig. 4).
Figure 4
Notch
6. Attach the A/C adaptor jack to the base power cord. DO NOT plug into outlet at this
time (Fig. 1).
7. Set the fountain on a level, waterproof surface.
8. Plug the cord into 120V household outlet. The fountain is controlled by the switch
located on the power cord. If pump doesn’t operate, rotate in-line switch once to turn
“on” and once more to turn “off”. Monthly maintenance will add to your pump’s life.
NOTE: Ensure that the electrical cord loops below the electrical outlet to form a ‘Drip
Loop’ (Fig. 5). This will prevent water from running down the cord into the electrical
outlet.
9. Arrange the glass stones provided around the base of the candle. (If splashing
occurs, rearrange stones until their is no more splashing).
Figure 5
Drip Loop
