HOMEDEPOT PK1101 POWERKING, Operating Instructions Manual, Page: 16 / 25

GB
19 / 30
of out put shaft.(Fig.1-5)
2. Loose the nut with the socket spanner by turning it in clock wise direction (viewed from above),
then remove the cap,the retainer and the blade from the output shaft.(Fig.1-5,1-6)
3. Refit the blade, aligning the cent HU of the blade.
4. Assembly the front flange and the cap, and then tighten the nut.
5. Remove the allen key.
WARNING!
Never use non-recommended cutting attachments and
KDYH appropriate guards DWWDFKHG . The non
approved cutting attachments may cause serous injure during working.
Fitting the spool(Fig.1-5,1-6,1-7)
1. Insert the 4mm Allen key into these circular opening on the backside of blade/spool to prevent
turning of output shaft.(Fig.1-5)
2. Loose the nut with the socket spanner by turning it in clockwise direction(viewed from above), then
remove the cap, the flange and the blade from the output shaft(if applicable).(Fig.1-5,1-6)
3. Screw the edge trimmer head onto the thread of output shaft by turning it in anti-clock wise
direction (viewed fromabove) (Fig.1-7)
4. Remove the allen key.
Replace the spool (Fig.1-5,1-7)
1. Insert the 4mm Allen key into these circular opening on the backside of blade/spool to prevent
turning of output
shaft.(Fig.1-5)
2. Loose the edge trimmer head by turning it in clockwise direction (viewed from above). (Fig.1-7)
3. Screw the new trimmer head on to the thread of output shaft by turning it in anti-clock wise
direction until tightening (viewed from above) (Fig. 1-7)
4. Remove the allen key.
WARNING!
Never use non-recommended cutting attachments and appropriate guards and their location.The
nonapproved cutting attachments may cause serous injure during working.
Assembly the two-piece tube (Fig.1-8)
Using one hand press the pressing plate of the pipe connector
Using the other hand insert the front aluminum tube into the pipe connector, until the pressing plate insert
the slot of front aluminum tube,
1) Fasten the pattern lock knob
WARNING!
The pressing plate of pipe connector must be insert the slot of the front aluminum tube, unless it is very
dangerous when the machine working, and the front aluminum tube will be rotated.
OPERATION
Before use
Please always read the instruction manual carefully and check the machine before operating. WARNING!
The brush cutter is fitted with a two-stroke engine. Fill the oil mixed with fuel , please consult
below section.
Check the cutting attachment,
never use blades that are dull, cracked or damaged.
Make sure the handle and safety features are in good working order. Never use a machine that lacks a
part or has been modified outside its specifications.
The enclosures must be correctly fitted and undamaged before you start
the machine.
WARNING!
Please always use quality gloves,
foot, ear and eye protector. They should with CE mark and
tested according to PPE(Person Protective Equipment) directive.