Net Weight: About 0.25kg
Function Introduction
Fig.1
Power Supply/ Balance Switch—
used as on/off power supply, also as balance
button. First, press the power supply once lightly, the signal strength LED will flash 2
times, and the vibrator will vibrate 2 times for a short time. Then the white lighting
LED will light, which means the locater is connected and completes balance, it enters
the using state.
Press the power supply switch for about 3 seconds. The white lighting LED will
extinguish and the power supply will turn off.
The power switch also can use as the balance button. Whenever you press the
power supply once lightly, it will balance automatically.
LED signal strength indication and vibration alarm
-- When metal is
detected, the vibration motor begins to vibrate, and the red signal strengthen LED
lights up. As the probe moves closer to the metal targets, the vibration frequency will
become higher .The signal strength LED will light up in the order of red, green, blue
and white .Until the white LED lights up, the motor vibration frequency is the highest.
Lighting LED
--
After the locater is turned on, the white lighting LED is on,
indicating the detector is in the work and it can also be used as a flashlight.
Search Probe
--
The built in antenna is for transmitting and receiving signals. The
front 2-3 cm, 360 ° is the higher sensitivity detection area.
Low voltage alarm
-
-When the battery is low, the LED will flash continuously. It
means it is time to replace the 9V battery.