HOMEDEPOT DB30TBN-LP, Use And Care Manual

Page: 8 / 24

8
Installation (continued)
5
The fan blade assemblies are to be attached to the motor using the blade
holder screws (1) that are pre-installed into the fan motor. The procedure
to attach blade assemblies is as follows:
Figure 12
Remove the pre-installed blade arm screws and washers (2 each per
blade assembly) through the window at the bottom of the light kit.
Align the 2 holes in the blade arm to the 2 holes in the motor through
the window at the bottom of the light kit and tighten back the screws
and washers.
Repeat these steps to install the remaining blade assemblies.
Figure 13
Attaching the fan blades
Mount the blade holders (D) to the fan blades (E) using the
blade screws (AA), hex nuts (CC) and flat washers (DD)
provided - 3 each per blade (Figure 12).
AA
E
When the electrical connections have been
made, take the fan off the hook. Slide the ceiling
canopy up the downrod, making sure that the
ball joint groove engages with the ceiling canopy
entry hole tab. Slide the bayonet slots on the
ceiling canopy onto the screws at either end of
the mounting plate, secure with the four screws
provided (Figure 11).
Figure 11
Finishing the installation
Downrod
Ceiling
Canopy
Bayonet
Locating Slot
Screw
Hole
Mounting
Plate
Groove
Tab
1
6
NOTE:
finish which best accentuates your decor. Failure to follow
below procedure could result in fan wobble.
Your fan blades are reversible. Select the blade side
CC
DD
D
DB30TBN/ORB/WH-LP