7
HOMEDEPOT.COM/HOMEDECORATORS
Please contact 1-800-986-3460 for further assistance.
Assembly - Standard Ceiling Mount
Routing the wires
Assembling the fan
Preparing for mounting
□
Route the wires exiting the top of the fan motor assembly (E)
through the decorative motor collar cover (D) and then the
center of the magnetic canopy bottom cover (FF).
□
Make sure the opening of the canopy (C) is on top and insert
the ball/downrod (B) through the canopy (C).
□
Route the wires exiting the top of the fan motor assembly (E)
through the downrod as shown.
2
3
1
□
Loosen, but do not remove, the setscrew (HH) on the collar (GG) on
top of the fan-motor assembly (E).
□
Align the holes at the bottom of the ball/downrod assembly (B) with
the holes in the collar on top of the fan-motor assembly (E).
□
Carefully insert the hanger pin (AA) through the holes in the collar
and ball/downrod assembly (B). Be careful not to jam the hanger
pin (AA) against the wiring inside the ball/downrod assembly (B).
□
Insert the locking pin (BB) through the hole near the end of the
hanger pin (AA) until it snaps into its locked position.
□
Re-tighten the setscrew (HH) on the collar (GG) on top of the fan-
motor assembly (E).
CAUTION:
To ensure wobble-free operation and to avoid
damage to the fan, the downrod (B) and the setscrew (HH)
must be completely tightened.
□
Remove the magnetic canopy bottom cover (FF) from the
canopy (C) by pulling it off.
□
Loosen the two canopy screws (EE) located in the bottom
of the mounting bracket (A).
□
Turn the mounting bracket (A) counterclockwise and lift it
up to remove the mounting bracket from the canopy (C).
C
A
EE
FF
NOTE:
The magnet is pre-attached on the canopy bottom
cover (FF) for you to remove and install easily.
C
D
E
FF
B
WARNING:
Failure to properly install the locking
pin (BB) could result in the fan becoming loose and
possibly falling.
C
D
E
FF
B
BB
AA
GG
HH
