s e c u r i t y
www.homezonesecurity.com
(888) 782-5618
• Slide the switch on the back of the Wall Light (Part C) to desired
position (Figure 1)
- Slide to "AUTO" position for the light to be activated by sensor
- Slide to "ON" position for the light to be on constant on mode
• Dial the switch on the side of the sensor to "moon" position as
shown in Figure 3.
• Loosen the screw at the bottom of the Security Light (Part A) as
shown in Figure 4 and remove the wall bracket.
• Choose desired wall location. Drill two holes on the wall (use the
two mounting holes on the wall bracket as template for the screw
locations as shown in Figure 5). Insert the plastic anchors (Part
E) and screw the wall bracket with the the two Screws (Part D)
into the wall tightly.
• Tighten the screw at the bottom of the light as shown in Figure 6.
Note:
For optimal performance, the security light should be
installed at a height of 6 to 7ft. (1.8 to 2.1m) above ground level.
• Choose desired wall location. Drill two holes on the wall (use the
two mounting holes as template for the screw locations as shown
in Figure 2). Insert the Plastic Anchors (Part E) and screw two
Screws (Part D) into the wall, leaving about 2mm long thread.
• Hang the Wall Light (Part C) on the screws.
Note:
Lights with solar panels may have a protective film over the
solar panel. This must be removed prior to use.
HOW TO OPERATE AND INSTALL
Intelligent Solar
3PK Wall Light Kit
Model No. ELI0980G
s e c u r i t y
Solar Wall Light
Figure 1
Figure 2
Solar Security Light
Install Security Light Fixture
AUTO-OFF-ON
Figure 3
Figure 4
Figure 5
