HOME WATER EZ CHANGE, Manual

Page: 5 / 8

Prior to Installation:
1. Filter should be installed indoors in a temperature controlled
environment.
2. Filter should be installed right after the house water meter
and prior to any branch-off plumbing lines to ensure all taps
receive filtered water.
3. Turn off main water supply to stop incoming water. Turn on
a cold water tap on a lower level faucet to drain the lines.
Preconditioning the filter prior to installation:
1. It is very important to properly flush the filter; there are
carbon fines that need to be flushed out prior to installation.
2. Connect a garden hose to the inlet port of the filter (marked
“In”) and slowly begin to fill the vessel with water.
3. Water will begin to flow from the outlet port of the filter, use
a bucket or drain to catch the water.
4. The first few gallons will be cloudy and black. Continue this
process for 15 minutes.
5. After 15 minutes begin to “Surge Flush” the filter by turning
the water supply off for 30 seconds then on for 30 seconds
and continue this for 15 more minutes or until the initial water
surge is free of cloudiness and discoloration.
6. Disconnect the garden hose, the filter is now ready for
installation.