Assembly Instructions
3
IMPORTANT
* Please keep Hex Wrench in a safe place as you may need to tighten up the Head Cap Bolts in the future.
* Do not tighten up all the bolts until each part is properly assembled.
* Use a soft cloth between these parts and the floor.
STEP 1
Attach End Panels (B) to Side Panel (A)
with Head Cap Bolts (long) and
Flat Washers (small).
(See figure 1)
Slide Playing Field (C) into position.
Attach Side Panel (A) to
unit with Head Cap Bolts (long)
and Flat Washers (small).
STEP 2
Insert Flat Head Screws (middle)
into the pre-drilled holes of playing
field.
Attach Leg (F) to unit with Head
Cap Bolts (short) and Flat Washers
(large).
Insert Bar (D) into the pre-drilled
hole of Leg (F).
Attach Leg (E) to unit with Head
Cap Bolts (short) and Flat Washers
(large).
Repeat this step on other end of
unit.
B
B
B
B
B
D
B
E
B
F
B
C
B
A
B
A
Head Cap Bolt (long)
Flat Washer (small)
Flat Washer (small)
Head Cap Bolt (long)
Flat Washer (large)
Head Cap Bolt (short)
Flat Head Screw (middle)
Figure 1
/6
11
11
12
2
5
13
13
