AC-AMC-1137
B
D
I
C
IMPORTANT!! PLEASE READ ENTIRE INSTRUCTION SHEET BEFORE ASSEMBLY!!
TO EXPEDITE ANY FUTURE WARRANTY CLAIMS, PLEASE KEEP INSTRUCTION SHEET, WARRANTY CARD AND RECEIPT
Figure 1
Step 2:
Insert the center spring rail(C)into the bracket on the
inside of base&arm assembly(B)and loosely attach
using the screws(D)and washers(I) as indicated in
Figure1.Do not tighten any of the screws until all four
have been started. Make sure all four legs are evenly
contacting the surface on which the chair is sitting and then
securely tighten each of the four screws using the hex wrench-2
(K).
Do not to over tighten the any of the screws. Over
tightening may strio bolts or damage the welds or frame
.
Note: Make sure the spring rails (C)is inserted as indicated in
Figure1.Before tighten the screw, adjust the seat frame
to be straight with the base
&
arm assemble
.
Step 1:
Remove all protective materials and set parts on a
flat, non-abrasive surface. Identify parts packed in
carton against the parts list. If you are missing any
parts or are unsure how to proceed with the assembly,
call our Customer Service Center at 1-800-206-8095.
Do not attempt to assemble table if any parts are
missing or damaged
.
Step 3:
Align
the
holes
in the
“
U
”
bar
,
located
underneath the
seat frame(A),with the
holes
in
the
metal
spring
plates
of
the spring
rail(C).Attach
the seat
frame(A)using
the
screws(E),metal
plates(G)spring washers(F)and
nuts(H)
as
indicated in Figure
2.
Once
all
four
have been inserted,
tighten each screw and nut using the hex wrench-1 (Q) and
hex wrench-2 (R).
Do not to over tighten the any of
the
screws
.
Over
tightening
may
strio
bolts
or
damage
the
welds
or
frame
.
Figure2
QTY
5/16" X 22 MM
BOLT
E
8.5 X 2.0 MM
SPRING WASHER
5/16"NUT
METAL PLATE
PARTS LIST
DESCRIPTION
4
4
4
1
1
4
A
B
C
D
E
F
5/16" X40 MM
BOLT
4
1
SPRING RAIL
* NOTE: PARTS SHOWN ON PARTS LIST ARE NOT TO SCALE
SEAT FRAME
BASE &ARM
ASSEMBLY
G
H
I
J
K
L
M
N
E
8.5 X 1.5 MM
WASHER
HEX WRENCH-1
1
HEX WRENCH-2
1
4
Step 4
:
Place the seat cushion (
M)back cushion(L),and pillow
(N)on each chair as indicated in Figure3.Secure the
seat cushions to the chair frames using the attached
straps with hook &loop fasteners
.
Then
your
chair
should
be
ready
for
use
.
1
1
Figure3
BACK CUSHION
PILLOW
1
SEAT CUSHION
Page 2
"U" BAR
ROCKER
ASSEMBLY
FRONT
E
G
F
H
G
