7
HOMEDEPOT.COM/HOMEDECORATORS
Please contact 1-800-986-3460 for further assistance.
Assembly - Standard Ceiling Mount
Routing the wires
Preparing for mounting
□
Remove the magnetic canopy bottom cover (JJ) from the canopy
(C) by pulling it off.
□
Loosen the two canopy screws (HH) located in the bottom of the
mounting bracket (A).
□
Turn the mounting bracket (A) counterclockwise and lift it up to
remove the mounting bracket from the canopy (C).
□
Route the wires exiting the top of the fan motor assembly (E)
through the decorative motor collar cover (D) and then the center
of the canopy bottom cover (JJ).
□
Make sure the opening of canopy (C) is on top and insert the ball/
downrod (B) through the canopy (C).
□
Route the wires exiting the top of the fan motor assembly (E)
through the downrod as shown.
2
1
NOTE:
The fan comes with 12 in. lead wires for use with
the provided 6 in. ball downrod assembly (B). If you wish
to use a longer downrod, attach the extension wire (J) to
the fan by connecting the molded adaptor plugs from the
extension wires to the adaptor plugs from the fan.
Assembling the fan
□
Loosen, but do not remove, the setscrew (KK) on the collar (PP) on top of the
fan-motor assembly (E).
□
Install the ball/downrod assembly (B) by inserting it into the motor collar (PP),
and turning it clockwise until the holes at the bottom of the ball/downrod
assembly (B) align with the holes in the collar on top of the fan motor assembly
(E).
□
Carefully insert the hanger pin (CC) through the holes in the collar and ball/
downrod assembly (B). Be careful not to jam the hanger pin (CC) against the
wiring inside the ball/downrod assembly (B).
□
Insert the locking pin (DD) through the hole near the end of the hanger pin (CC)
until it snaps into its locked position.
□
Re-tighten the setscrew (KK) on the collar (PP) on top of the fan motor
assembly (E).
WARNING:
Failure to properly install the locking
pin (DD) could result in the fan becoming loose and
possibly falling.
CAUTION:
To ensure wobble-free operation and to avoid
damage to the fan, the downrod (B) and the setscrew (KK)
must be completely tightened.
3
A
HH
C
JJ
C
JJ
B
E
D
E
B
KK
CC
DD
PP
D
JJ
C
