Please read and understand this entire manual before attempting to assemble, operate or install the product.
This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC
Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation.
This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the
instructions, may cause harmful interference to radio communications.
However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause
harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user
is encouraged to try to correct the interference by one or more of the following measures:
□
Reorient or relocate the receiving antenna
□
Increase the separation between the equipment and the receiver
□
Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
□
Consult the dealer or an experienced radio/TV technician for help.
This device complies with Industry Canada Licence-exempt RSS-210. Operation is subject to the following two conditions:
(1) this device may not cause interference, and
(2) this device must accept any interference, including interference that may cause undesired operation of the device.
CAUTION:
To maintain compliance with the RF exposure guidelines, place the base unit at least 20cm from nearby persons.
WARNING:
Changes or modifications to this unit not expressly approved by party responsible for compliance could void the
user’s authority to operate the equipment.
□
Make sure the unit is turned OFF, unplugged and the heating elements of heater are cool whenever you are cleaning the heater.
□
Clean the metal trim using a water-dampened soft, clean cloth. DO NOT use brass polish or household cleaners as these products will
damage the metal trim.
□
The motors used on the fan and the flame generator assembly are pre-lubricated for extended bearing life and require no further
lubrication. However, periodic cleaning/vacuuming of the fan/heater and air intake/output vents is recommended.
□
Any other servicing should be performed by an authorized service representative.
20
HOMEDEPOT.COM/HOMEDECORATORS
Please contact 1-800-986-3460 for further assistance.
Operation
FCC/IC Information
Operation
CARE AND MAINTENANCE
WARNING:
Make sure the power is turned off before
proceeding. Any electrical repairs or rewiring of this unit
should be carried out by a licensed electrician in
accordance with national and local codes.
WARNING:
Disconnect power before attempting any
maintenance or cleaning to reduce the risk of fire,
electrical shock or personal injury.
WARNING:
During any service of this appliance, the
power to the unit must be turned off. First turn the main
power switch to the “OFF” position. Then remove the
electrical plug from the wall outlet.
WARNING:
If repairing or replacing an electrical
component or wiring, the original wire routing, color
coding and securing locations must be followed.
WARNING:
Electrical outlet wiring must comply with
local building codes and other applicable regulations to
reduce the risk of fire, electrical shock and injury to
persons.
WARNING:
Do not use this fireplace if any part of it
has been under water. Immediately call a qualified
service technician to inspect the fireplace and replace any
part of the electrical system.