12
Assembly (continued)
15
Attaching the back panels
□
Pick up the upper back panel (D) and align the drilled holes against the upper long edge with the pilot holes on the back stretcher of
the top panel (A). Attach the upper back panel (D) in place using the provided washer head screws (FF).
□
Align and attach two lower back panels (I) to the lower side panels (J and M) and partition panels (K and L) with the provided washer
head screws (FF), using the pilot holes as a guide.
16
Installing the doors
□
Stand the assembled unit upright.
□
Pick up the left door (G) and attach the extended hinge arms to the hinge bases installed on the left side panel (J). Loosen the bolt on
the back of the hinge base for an easy fit. Align and insert the “U” slot on the hinge arm under the bolt head on the back of the hinge
base. Make sure that both door hinges engage and function properly. Tighten the bolt on the hinge base to lock the hinges in place.
□
Repeat the same procedure to attach the right door (H) at the opposite side.
□
Open and close the doors to make sure they are aligned and shut correctly. If necessary, adjust the screws for a good fit. Refer to the
hinge sticker on the door for adjustment.
FF
I
M
R
K
B
C
I
D
1
J
M
G
H
UP
UP
