NOTE: Always test the gas hose
for leaks at connectors with
soapy water after finishing.
Apply caution when changing
the gas bottle and keep away
from naked flames.
NOTE: Be careful not to kink
flexible portion of gas hose.
General Information
WARNING: The Minimum Safe
Distance between the Gas
Cylinder and any other
combustable materials should
be a Minimum of 1.0m. Do not
place flamable material close to
the burner as this is a Hazard.
Place the Unit on a Level
Surface where it will not be
easily knocked over and away
from Children and Pets.
•
Only change the gas cylinder in
well ventilated areas away from
any inflammation source (candle,
cigarettes other flame producing
appliances...).
•
Ensure that the regulator seal is
fitted and in good condition.
•
Turn off the gas at the regulator
or gas cylinder after use.
How to disconnect the gas bottle:
1. Check that the control knob and
regulator are in the OFF position.
2. Disconnect the regulator from the
gas bottle valve.
3. Position gas bottle below or near
heater.
4. Attach gas hose to gas bottle -
make sure the lever is in the down
position and push in with your
thumb while pushing regulator
down firmly until a "click" is heard.
Release thumb from lever.
See fig. 9.
Assembly Instructions
Assembly Instructions
Stage 4 –
Preparation
Type of Regulator to be used:
• Low pressure L.P. Gas Regulator.
•
Nom. Outlet Press. 37 mbar
•
Max. Inlet Press. 20 bar
•
Propane LR2527A
•
British Standard : BS3016
•
Safety ø27 Interlock
See fig. 10.
Regulator
fig. 10
Gas
Bottle
Stage 4 –
Preparation
How to connect the gas bottle:
1. Check that the control knob and
regulator are in the OFF position.
2. Slide hose clamp over each end
of hose. Slide hose over nozzle of
regulator. Route hose through
table before connecting to nozzle.
Tighten clamps.
Gas bottle connection
Regulator
fig. 9
Gas
Bottle
