4.OPERATING YOUR NASAL IRRIGATOR
Note : Prior to initial operation,the Nasal irrigation bottle and air tube should be
thoroughly cleaned.
1.
Place your Nasal irrigation bottle
on a flat and stable surface.Be sure
easily reach the controls when you are seated.
2. Gently twist the top part of theNasal irrigation bottle counter-clockwise to
disassemble the Nasal irrigation bottle.
3. Fill the bottom section of the Nasal irrigation bottle with the medication
prescribed by your
physician.
4. Gently twist the top part clockwise to assemble the Nasal irrigation bottle. Be
-
sure the
two sections fit well.
5. Attach one end of air tube to the base of the Nasal irrigation bottle .
6. Attach the other end of air tube to the air tube connector located on the
front of the compressor.
7. Plug the power adapter into an appropriate electrical outlet.Make sure
at this stage,the power switch is at “OFF”status.
8.
Press power switch to begin your prescribed operation.
9. Hold the Nasal irrigation bottle in hand, press the air adjusting hole gently with
your finger, and then water mist sprays out from the spray nozzle to complete the
cleaning procedure.
10. After using, rinse the nasal irrigation bottle with clean water and spray the liquid in
the bottle to avoid blocking the spray head.
Nasal irrigation methods
1.
Cleaning of nasal front : Head slightly forward in clined, the nozzle aimed at the
nostril for cleaning, the nasal vestibular secretions wet, to blow out in the way of
nose blowing, alternate irrigation of the left and right nasal cavity;
3
