ASSEMBLY
1 Remove the Try-Me Button
Remove the packing and take out the product carefully. Place all parts
flat on the ground. Disconnect the plug on the Try-Me Button (C) from
the controller .
2 Assembling the Clown Head and Controller to the Stake
Insert the non-pointed end of the Stake (D) into the connecting hole at the
bottom of each Clown Head (A) and the Controller (B) until firmly tight.
Note: Handle the handle Clown Head (A) with care while performing this
task.
3 Anchoring the Ground Stakes
Insert the Ground Stakes (D) into the ground by grasping the Ground
Stake in the middle then firmly pushing into the ground. Note: Do not
push down on the top of the Clown Head. This could cause breakage.
Hint: If the ground is hard use water to moisten the ground for an easier
install.
4 Accessing Battery compartment on Controller
Loosen the screws on the cover on the back side of the Controller (B).
Remove the back cover of the Controller away from the body of the
Controller.
5 Installing and Replacing the Batteries
Fit the batteries, requires 3 AA Batteries (sold separately), one after
another, into the Battery Compartment of the (Controller). Make sure
the Batteries are placed in the correct direction with the polarity
matching what is indicated on the inside of the Battery box.
6 Securing the Battery compartment cover on Controller
Place the cover on the back side of the Controller. Place the screws into
the screw holes and tighten firmly taking care not to strip the threads.
7 Operating
the
Controller
On the back side of the Speaker is a power switch.
Move the switch to ON. This will activate the built in sound sensor.
When the sound sensor is activated the speaker will play phrases
and the Clowns mouths will move.
