Optional: To adjust the tightness of joint rotating, Use big Hex Key in the (K) Polybag
with Small Parts to adjust the nut at the joints as shown in Figure 3.
BATTERY BOX
LOCATED
UNDER THE
HEAD OF THE
SPIDER
H
I
C
2/2
Do not mix alkaline, standard (carbon-zinc), or rechargeable (nickel cadmium) batteries. Do not mix old and new batteries. Rechargeable batteries to be removed from the product before being charged.
Only batteries of the same or equivalent type as recommended are to be used. Rechargeable batteries are only to be charged under adult supervision. Non-rechargeable batteries are not to be recharged.
Batteries are to be inserted with the correct polarity. Remove batteries if consumed or if product is to be left unused for a long time. The supply terminals are not to be short-circuited. Dispose of batteries
safely. DO NOT DISPOSE OF BATTERIES IN FIRE, BATTERIES MAY EXPLODE OR LEAK
This switch mode will activate lights and sound when the Infra-red (IR) sensor is activated and will
operate for 1 audio-cycle with each activation. The Infra-red (IR) sensor has a range of up to 2
m/6.5 ft. and will activate when somone comes within an 80-degree angle from left-to-right, as
well as from above and below.
: This setting will turn off lights and sound.
: This switch mode will continually operate the lights and sound of the item.
: Raise or lower the volume using the volume control turn dial, turn and click all the way down to
turn the volume off.
OPERATION INSTRUCTIONS
BATTERY REPLACEMENT INSTRUCTIONS
Requires 3 x 1.5V AA batteries (Included)
* You will need a small screwdriver (Not Included).
Locate the battery compartment on the product. Remove the battery compartment cover by using a small Phillips head screwdriver to unscrew the screw. After removing or installing the batteries, place
the battery compartment cover into position, and secure the battery cover. DO NOT overtighten screws.
FOR OUTDOOR USE
F
WARNING
This item is not a toy and should be used for decoration only. This item contains small parts that can be a choking
hazard. Keep all plastic and wire parts away from children.
1. Please use the adapter supplied by manufacturer.
2. Please assemble item according to instructions. Connect all wires according to matching color.
3. Children should be supervised by adults. Item should not be grabbed, as it becomes a tipping
hazard. Keep flammables away from the adapter, as it heats up during operation.
Please view all instructions carefully before assembling. Save this instruction sheet for future reference.
CARE AND STORAGE INSTRUCTIONS
For best performance operate your item indoors. When not in use, store this product in its original packing. Keep
away from heat and moisture.
This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) this device must accept any
interference received, including interference that may cause undesired operation.
CAUTION:
Changes or modifications not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment.
NOTE:
This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection
against harmful interference in a residential installation. This equipment generates, uses, and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may
cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio
or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures: Reorient or relocate
the receiving antenna, Increase the separation between the equipment and receiver. Connect the equipment into an outlet on a circuit different from that to which the receiver is connected. Consult the
dealer or experienced radio/TV technician for help.
CAN ICES-3(B)/NMB-3(B)
© Seasonal Visions International
Emeryville, CA 94608
Tel: 510-428-3921
All Rights Reserved
MADE IN CHINA
Sensor:
5.1