Step 5. Shape the branches. Starting with tips closest to the pole, shape
one tip to the right, one to the left and one at the center of the main
stem. Repeat pattern for each branch. (See Fig. 5)
Step 6. Plug the well-connected power cord from the tree section (C) into
a proper outlet. Please note this tree comes with a foot pedal
switch and remote control for easy illumination and changing
functions. This tree is Color Changing, the 8 lighting options
available are:
1.
Warm White Steady
2.
Warm White Flashing
3.
Warm White Slow Fade
4.
Multi Steady
5.
Multi Flashing
6.
Multi Slow Fade
7.
Warm White-Multi Sequential
8.
Warm White-Multi Color Changing
These functions can be changed by pressing the foot pedal
switch or using the remote control. Please see the instructions of
remote control below.
Instruction of remote control
Please note this tree has a remote control.
Please pull out the insulation tape from the remote control, before starting
to use it.
1.
Press Fn button, the function below cycle. Press the number key,
select from the following corresponding lighting functions:
Function 1: Warm White Steady
Function 2: Warm White Flashing
Function 3: Warm White Slow Fade
Function 4: Multi Steady
Function 5: Multi Flashing
Function 6: Multi Slow Fade
Function 7: Warm White-Multi Sequential
Function 8: Warm White-Multi Color Changing
There is memory mode on function adjustment.
If the remote control does not work, check whether the battery of the
remote control is out of power.
To replace the remote control battery:
1.
Replace with a new button cell “CR2025” (3 volt) into
the compartment.
CAUTION:
DO NOT DISPOSE OF
BATTERIES IN FIRE. BATTERIES MAY EXPLODE
OR LEAK.
Turning on the tree
Step 1. Plug the well-connected power cord from the tree section (C)
into a proper outlet.
Replace the fuse.
1.
Fuse replacement of power supply cord from bottom section (C)
(replaceable 3 amp, 125 volt fuse is located in spare parts bag):
This plug will fit in a polarized outlet only one way. If the plug does
not fit fully in the outlet, reverse the plug. If it still does not fit,
contact a qualified electrician. Do not use with an extension cord
unless plug can be fully inserted. Do not alter or replace the plug.
a)
Grasp plug and remove from the receptacle or other outlet
device. Do not unplug by pulling on cord.
b)
Open fuse cover. Slide open fuse access cover
on top of attachment plug towards blades.
c)
Remove fuse carefully.
d)
Risk of fire. Replace fuse only with 3 Amp, 125 Volt fuse
(provided with product).
e)
Close fuse cover. Slide closed the fuse access cover on top of
attachment plug.
f)
Risk of fire. Do not replace attachment plug. Contains a safety
device (fuse) that should not be removed. Discard product if the
attachment plug is damaged.
Replace the lamp.
a)
Grasp plug and remove from the receptacle or other outlet device. Do
not unplug by pulling on cord.
b)
Unlock the burned out LED bulb by lifting the hook and pulling both
the bulb and plastic base straight out of the bulb holder. Do not twist
bulbs.
c)
Replace burned out bulb with 3.0 volt, 20 mA LED type bulb ONLY.
(Replacement bulbs included)
d)
Lock the LED bulb.
CAUTION
1.
To reduce the risk of overheating, replace burned-out lamps promptly.
Use 3.0 Volt, 20 mA LED lamps only.
2.
Risk of fire. This product does not contain lamp shunts, which allow the
product to operate if one lamp burns out. Replace lamps only with the
spare lamps provided with this product.
Operation
Maintenance
