4
The heater shall be installed into a location that has an opening with dimensions below:
• Width: minimum 745mm
• Height: minimum 525mm
• Depth: minimum 235mm
· Make sure the distance between the appliance and the wall is more than 100mm
· Make sure the distance between the appliance and two sides, top of the mantel is more than
100mm.
· Plug in the appliance and push the appliance slowly into the mantel.
·Fix the fireplace with the fixing bracket and screw (see Fig.1 in circle)
Instructions for Use
The appliance can be operated either by the switches located
at the front right hand side above the
fire or by the supplied remote control.
Manual Operation
· The switches located at the front right hand side above the fire .The standby switch must be first
switch on.
· Press once the O/I button to turn on the appliance and flame effect. A red indicator light will
appear to indicate that the function is ON. Press the O/I button for 3 seconds this will operate the
dimmer mode.
· Press the 750W button once for the low heat settings; press twice to switch off the heat setting.
· Press the 1500W button once for the high heat settings; press twice to switch off the heat setting.
Remote Operation
· The standby switch located at the front right hand side above the fire must be first switch on..
· It takes some time for the receiver to respond to the transmitter. Do not PRESS the buttons more than once
within two seconds for correct operation.
1) Connect the power
2) Turn on the power switch
3)Press the ON/OFF key of the remote controller to start up
4) Press the 750W button for the low heat settings; press twice to switch off the heat setting.
5) Press the 1500W button for the high heat settings; press twice to switch off the heat setting.