Holzstar 5900255, Instruction Manual, Page: 13 / 24

5, Attach the support bracket to the swing
arm (A) and
Þ x it by 1-M20 mm nut.
Attach the sliding table frame to the sliding
carriage, with the square nut insertting into
the T-slot of the sliding carriage.
(Figure 22 - 1)
M20 Nut
Square Nut
A
Figure 22 - 1
6, Slide the sliding carriage forward to the
end, and then slide the sliding table forward
to the end,
Þ x the sliding table tightly by two
wing screws. (Figure 22 - 2)
8, Place the clamping plate (A) on the sliding
carriage, and
Þ x it by knuled Screw (B).
(Figure 24)
9, Place the Miter Gauge on the major table,
with the miter gauge rod on the T-slot of
major table. (Figure 25)
A
B
Figure 24
Figure 25
6.9 Mains Connection
Danger! Electrical Hazard!
• Operate the machine in dry environment
only.
• Operate the machine only on a power
source matching the following requirements:
- mains voltage and system frequency
conform to the voltage and frequency
shown on the saw’s name plate;
- outlets properly installed, earthed and
tested,
• Position power supply cable so it does not
interfere with the work and is not damaged.
• Protect power supply cable from heat,
aggressive liquids and sharp edges.
• Do not pull on power supply cable to
unplug.
7, Take the extractable stop rail (A) from the
sliding carriage carton and put it onto the
sliding table frame, with the positon pin (B)
in the hole at the corner of the sliding table.
Set it verticle to the sliding carriage and
Þ x
it by fasten the wing screw (C) beneath .
Attach the ß ip stop (D) to stop rail (A) and
Þ x it by the wing screw. (Figure 23)
A
B
C
D
Figure 23
Figure 22 - 2
Check the surface alignment of the sliding
table and the sliding carriage. Make micro
adjustment by loosing the M16 mm nut, and
adjust 2-M6 mm bolts and 2-M6. (Surface
Alignment - 2)
M16 Nut
M6 Bolt & Nut
Surface Alignment - 2
13