TROUBLESHOOTING
HOLZMANN MASCHINEN GmbH www.holzmann-maschinen.at
39
HBS400
Therefore, clean the machine after each use and remove any sawdust with a brush, broom
or vacuum cleaner.
18.2
Maintenance
W A R N I N G
Handling the machine with the power supply up can lead to serious injuries or even
death. Always disconnect the machine from the power supply before servicing or
maintenance work and secure it against unintentional or unauthorised reconnection!
The machine is low-maintenance and only a few parts have to be serviced. Nevertheless,
malfunctions or defects which could impair the safety of the user must be rectified immediately!
Keep the bearing guides clean and free of deposits.
Do not allow sawdust to accumulate in the impeller boxes. Vacuum sawdust and sawdust
regularly.
Connect the band saw to a dust extraction system.
Clean and lubricate the lifting/lowering rod for the upper bearing guides if they are stiff.
Clean and lubricate the tensioning mechanism if it is stiff.
Check V-belt monthly for sufficient tension. If cracks or lateral tears are detected, the
drive belt must be replaced!
18.3
Storage
N O T E
Improper storage can damage and destroy important machine parts. Store packed or
unpacked parts only under the intended ambient conditions!
In case of a longer interruption of operation or shutdown, clean the machine and then store it out
of the reach of children in a dry place protected from frost and other weather influences!
18.4
Disposal
Observe the national waste disposal regulations. Never dispose of the
machine, machine components or equipment in residual waste. If necessary,
contact your local authorities for information on the disposal options
available.
If you buy a new machine or an equivalent device from your specialist
retailer, he is obliged in certain countries to dispose of your old machine
properly.
Troubleshooting
W A R N I N G
Handling the machine with the power supply up can lead to serious injuries or even
death. Always disconnect the machine from the power supply before servicing or
maintenance work and secure it against unintentional or unauthorised reconnection!
Many possible sources of error can be excluded in advance if the machine is properly connected
to the mains.