HOLZMANN MASCHINEN TK305, User Manual

Page: 35 / 141

OPERATION
HOLZMANN MASCHINEN GmbH www.holzmann-maschinen.at 35
TK 305
N O T I C E
Mitre saw:
 The workpiece must be pressed firmly against the circular pan and the mitre
gauge in all operations.
 Do not hold the workpiece with your hands near the blade.
 The circular pan must be properly secured and must not move during operation.
 The locking knob must be tightened during mitre cuts. Always check before
starting the cut!
 Handle securely hold! The handle moves when starting up slightly up or down.
Table saw:
 Guide the workpiece always on the rip fence.
 Check always the fixation of the work table before starting.
 Use to protect hands and fingers always the safety push stick during cuts less
than 300mm.
 Check the right setting and the kerf thickness before starting.
 Slide the workpiece never jerky or too fast.
 Do not twist or bend the workpiece.
 If the saw blade jams in the workpiece, turn off the machine immediately,
disconnect it from the power supply and rid the saw blade
17.2 Operation
17.2.1 Initial check before start
 Check that the speed of the machine is lower than the max. permissible speed of the saw
blade used.
 Check saw blade rotation and saw blade dimensions to match the machine.
 Check that the saw blade guard works properly.
 Check whether the connection to a dust collection system is installed.
 Check whether the stops/fences are set correctly and the saw blade is tightened.
 Check whether the machine is fixed on the working plate or a machine stand.
 Check whether the saw blade can run freely.
17.3 Table saw level cutting
Install all accessories and connect the power. By pressing the ON/OFF-button the machine will be
start.
1.
Select and cut objects thickness cannot
overstep 55mm of the table mode cutting size.
2. According to your actual required of cutting
length to adjust the “table orientation plate
groupware” location.
a. Put the cutting objects on the table working
face.
b. Select the cutting data of yours requirement.
c. When the cutting size was determined, Please
position the “Cutting & position size knob”.
3. Hold the “Safety plush stick” and plush the
cutting object forward until it to sever.