ASSEMBLY
HOLZMANN MASCHINEN GmbH www.holzmann-maschinen.at
18
RWH250Hybrid | RWH300 | RWH400
11.5.1
Residual risks
Risk of injury (crushing) to hands/fingers during operation.
Risk of injury by the tilting of the product.
Note that working under a vehicle is very dangerous even if the vehicle is supported by
the product and secured by additional supports. Always be careful and observe throughout
the jacking operation, if the saddle is fixed on the vehicle lifting point and if there are any
possible movements.
Due to the design and construction of the product, hazardous situations may occur when handling
the product, which are identified as follows in these operating instructions:
D A N G E R
A safety instruction designed in this way indicates an imminently hazardous situation
which, if not avoided, will result in death or serious injury.
W A R N I N G
Such a safety instruction indicates a potentially hazardous situation which, if not
avoided, may result in serious injury or even death.
C A U T I O N
A safety instruction designed in this way indicates a potentially hazardous situation
which, if not avoided, may result in minor or moderate injury.
N O T I C E
A safety notice designed in this way indicates a potentially hazardous situation which,
if not avoided, may result in property damage.
Irrespective of all safety regulations, your common sense and appropriate technical
suitability/training are and will remain the most important safety factor for error-free operation of
the product. Safe working primarily depends on you!
12
ASSEMBLY
12.1
Preparatory activities
12.1.1
Checking delivery content
Always note visible transport damage on the delivery note and check the product immediately
after unpacking for transport damage or missing or damaged parts. Report any damage to the
product or missing parts immediately to your retailer or freight forwarder.
12.2
Assembly
The product is delivered pre-assembled. Only the components removed for transport must be
assembled according to the following instructions.
Assembly lower lever
Press the lever bar (1) down to remove the
mounting block (2), which serves to fix the lever
bar during shipping.
