HOLZMANN Maschinen Austria
www.holzmann-maschinen.at
Strana 19
Naftový horkovzdušný ohřívač / diesel gas burner HKD15 / HKD30T
13
ASSEMBLY
13.1
UNPACKING
Remove all protective material which may have been applied to the heater for shipment.
Remove heater from carton.
Check the heater for possible shipping damage. If any damage is found immediately notify
the dealer from whom you purchased the heater.
13.2
ASSEMBLY
HKD15 doesn’t need any assembly.
For HKD30T there are two additional hand frames.
Insert wheel axle (Part No. 44) into wheel frame (Part No. 43).
Insert the spacing pin (Part No. 72) in the wheel axle to fix.
Slide the wheel (Part No. 45) into axle.
Slide the washer (Part No. 50) into the axle.
Screw in the nut (Part No. 51).
Repeat c) to e) to assemble another wheel.
Put the heater on the assembled wheel frame.
Insert bolts (Part No. 47), washer (Part No. 49, if shock-proof nut used, it will be saved)
and Nut (Part No. 48), then tighten.
For HKD30T hand frames (Part No. 46) should be fixed together
Install the caps over the larger washers to finish the wheel assembly.
Summary of Contents for HKD15
Page 31: ......