HOLZMANN MASCHINEN ED 300FD, User Manual

Page: 30 / 54

SAFETY GUIDELINES
HOLZMANN MASCHINEN GmbH www.holzmann-maschinen.at Seite 30
METALLDREHMASCHINE / METAL TURNING LATHE ED 300FD
Any manipulation of the machine or its parts is a misuse, in this case HOLZMANN-Machines and
its sales partners cannot be made liable for ANY direct or indirect damage.
Even when the machine is used as prescribed it is still impossible to eliminate certain residual risk
factors.
W A R N I N G

Use only drills allowable for this machine!

Never use a damaged drill!

Use the machine never with defective or without mounted guard
HIGHEST RISK OF INJURY!
12.2.1 Ambient conditions
The machine may be operated:
humidity max. 70%
tempe5° С to +40° С (+41°F to +104°F)
The machine shall not be operated outdoors or in wet or damp areas.
The machine shall not be operated in areas exposed to increased fire or explosion hazard.
12.2.2 Prohibited use
 The operation of the machine outside the stated technical limits described in this manual is
forbidden.
 Operation of the machine function without emergency stop button or impeller box with open
doors is prohibited.
 The use of the machine not according with the required dimensions is forbidden.
 The use of the machine not being suitable for the use of the machine and not being certified is
forbidden.
 Any manipulation of the machine and parts is forbidden.
 The use of the machine for any purposes other than described in 12.1 is forbidden.
 The unattended operation on the machine during the working process is forbidden!
 It is not allowed to leave the immediate work area during the work is being performed.
12.3 Specific requirements for metal lathes
Apart from the information in this manual and the relevant work safety regulations , you must
follow the general operating and safety rules that are required when working with a metal lathe.
 When working with metal lathes no gloves.
These may get caught in rotating parts and cause serious injury.
 Keep at work the technical limitations such as max. A diameter etc.
 Check before work, whether the tool holder etc. are always properly secured.
 Tighten only workpieces in a chuck , which are of Ø ago for this purpose.
 Edit the fly , that is, without tailstock support only short workpieces.
 If the workpiece 3 times longer than the diameter of the workpiece , the workpiece should be
stored on each case, in addition to the tailstock.