
2 / 2
Make the PM06 show the quantity of electric charge of your battery
Mission Planner setup:
1.
Connect PM06 to the battery, also connect it to Mission Planner via USB.
2.
Click
“
INITIAL SETUP
”
and come to the menu
“
Battery Monitor
”
.
3.
Make
“
Monito
”
into
“
Voltage and Current
”
.
4.
Make
“
Sensor
”
into
“
Other
”
.
5.
Make
“
APM Ver
”
into
“
The Cube or Pixhawk
”
.
6.
Input
“
18.1
”
into Voltage divider (Calced).
7.
Input
“
36
”
into
“
Amperes per volt
”
.
8.
Disconnect and reconnect it to finish the setting up.
(“
Measured battery voltage
”
shows
the current quantity of electric charge of the battery.
)
Package Include
:
PM06 board*1
80mm XT60 connector wire*1
6pin GH cable *1
6pin JST cable *1