Holux GPS LOGGER M-241C, Manual, Page: 18 / 46

HOLUX GPS Logger M-241c User’s Manual
18
：
： ：
：Measure Distance Mode
Measure Distance Mode Measure Distance Mode
Measure Distance Mode
Menu Menu Menu Menu: Go to Setting mode
Enter
Enter Enter
Enter: Start / Stop to measure distance
Note:
1.
When user enables the “Measure Distance” function, the “ ” icon
will shows on the top-left corner of the screen
2. Because the satellite signal may be shifted easily due to the
interference when the moving speed is less than 10 km/hr or under the
environment with tall buildings that the satellite signal is not good, the
user may see the shift of the satellite coordinate while being in the static
state. Thus, while the distance is being measured, it is normal that there
might be accumulated error and the displayed total measured distance
will be different from the actual distance.
3. You can select the unit in setting mode, refer to km/mile menu.
：
： ：
：Setting Mode
Setting Mode Setting Mode
Setting Mode
Menu Menu Menu Menu: Go to Track Log Mode
page page page page
Enter Enter Enter Enter: Go to “Distance By” menu of Setting mode
Menu
Menu Menu
Menu: Go to Distance By menu of Setting mode
Enter
Enter Enter Enter: Go to select “Point” or “Route”
Note:
1.
“Distance By” signifies that Measure Distance is by “The beeline
between Begin Point and End Point” or by “Route (Path) of all
points”.