912-00167-001 REV.B
2.3.3
Wire input leads accordingly. Connect incoming
ground wire to ground wire attached to inside of wiring
chamber. Connect incoming common wire to white input
lead. Verify the luminaire voltage before connecting this
wire. Carefully place connections in wiring chamber for
future access.
2.3.4
Close door and fasten the latch onto the housing.
2.3.5
Energize the Luminaire, check for proper operation.
OPTICS ORIENTATION NOTES
Some of the fixtures in this series are equipped with optical
components that produce distributions of light that are not
symmetric and are intended to be aimed by orienting the
prismatic refractor a specific direction. The “
Street Side
”
marking on the refractor should be pointed toward the street.
The marking is on the top edge of the refractor.
3. Maintenance
3.1. Cleaning
3.1.1
Wipe off exterior dirt and debris using a soft, clean cloth.
3.1.2
Disengage latch, by rotating flat side toward center of
luminaire, and open top cover. Refer to Figure 1 or 2.
3.1.3
Remove clear plastic cylinder by lifting straight up.
3.1.4
Wipe plastic cylinder with damp soft cloth (do not use
chemical agents on plastic).
3.2
For non-cutoff luminaires wipe the refractor interior with a
clean dry cloth. Do
NOT
touch LEDs.
3.2.1
Close top cover and engage latch.
3.2.2
Energize the luminaire. Check for proper operation.
CAUTION
DO NOT USE ABRASIVE CLEANSERS ON OPTICAL
SURFACES. THEIR USE MAY RESULT IN THE LOSS OF
OPTICAL EFFICIENCY.
3.2. Electrical Component Replacement – MS
Only
3.2.1.
Loosen latch on swing open door. Open the door to
reveal internal components and electronics bracket.
3.2.2.
Disconnect black, green, and white, supply leads or
terminal block connection.
3.2.3.
Disconnect red and blue LED leads from the driver.
Observe how bracket is set on the door.
3.2.4.
Remove 2 EA screws at top of electronics bracket
and set aside. Bracket and attached components can
now be removed from the door. Ensure that all
connections to housing have been removed.
3.2.5.
Place new electronics bracket into door, replicate the
positioning from step 3.2.3.
3.2.6.
Fasten 2 EA screws from step 3.2.4 to secure the
bracket to the inside of the door.
3.2.7.
Close the door and fasten the latch onto the housing.
3.2.8.
Energize the luminaire. Check for proper operation
4. LIMITED WARRANTY AND LIMITAION OF
LIABILITY
The Holophane limited warranty and limitation of liability is
published in the "Terms and Conditions" section of the
current Holophane buyer's guide and is available from your
local Holophane sales representative.