Hologic R2 DM, User Manual

Page: 91 / 106

6.5. Resetting the Handheld Barcode Scanner
6.5. Resetting the Handheld Barcode Scanner
Occasionally it is necessary to reset the handheld barcode scanner software to its
default settings. If the barcode scanner stops reading barcodes properly, use the
barcode labels provided in this section to reset it.
X
To reset the handheld barcode scanner
1
Scan the ‘Enter/Exit Configuration Mode’ barcode shown below. When you scan the
barcode, the scanner should beep three times.
2
Scan the ‘Recall Defaults’ barcode. When you scan the barcode, the scanner should
beep once. This erases all previous settings and returns the barcode scanner to its
factory default communications settings.
R2 DM User Manual – PN MAN-01044 Rev 001 83