6
© HOLMS INDUSTRI AB, ALL RIGHTS RESERVED 5/4/06
HOLMS INDUSTRI AB
MOTALA SWEDEN
SAHL-L
Warning!
Always stop the broom completely before
making any adjustments.
Picture 8. Sweeper with even ground pressure
Picture 9. Sweeper tilted backwards
Picture 10. Sweeper tilted forwards
Picture 11. Supports in parking position
1. Set the sweeper height and tilt.
2. Let the sweeper rotate a short while against the ground .
3. Measure the clean-swept stripe, it shall normally be ca
150mm.
Reduce the ground pressure by unscrewing the rigging
screw and raise the ground pressure by tightening the
rigging screw (picture 7).
Sweeping
By sweeping the setting normally shall be as described in
”setting the sweeper, height and tilt”. The yellow markers on
the height- and tilting indicators shall be in line. In this
position the loader bracket is vertical to the ground. The
sweeper operates with even pressure over its whole width.
Attention!
Do not use the carrier height and tilting function
for ground pressure adjustment.
By requirement of harder ground pressure on any side of
the sweeper or if the sweeper is unevenly worn the
adjustment can be made by changing the tilt setting.
By backwards tilting harder pressure is reached on the side
of the sweeper which is angled towards the loader.
By forwards tilting harder pressure is reached on the side of
the sweeper which is angled from the loader.
Disconnecting from carrier
1. Loosen the attachment bracket faucets before the
sweeper is placed on the ground to avoid damage on the
suspension system.
2. Lower and secure the support in parking position.
Attention!
The sweeper brushes can be deformed if the
supports are not used when sweeper is parked.
3. Put down the sweeper to the ground and continue until
the bracket loosen from the carrier.
4. Put the transport catch in transport position (picture 4).
5. Loosen the quick couplings and the cable.