7
fig. F
Step 7: Carefully place the INSERT in the
unit opening. The front of INSERT should
be flush with the front of the mantel. Once
the INSERT is in place, attach 2 MOUNTING
BRACKET (O) with 2 SHORT KD SCREWS
back of the mantel on the floor. Carefully
lift the INSERT into the mantel until the top
stopper is against to MANTEL.
Attach 2 MOUNTING CLIPS (N) on the top
of insert and lock in place with 2 SHORT
KD SCREWS (O). Attach 2 MOUNTING
BRACKETS (P) onto the bottom of insert with
2 MEDIUM KD SCREWS (Q). See Fig. G.
fig. G
Step 8: Tighten all KD SCREWS.
Step 9: Carefully move the assembled unit
to the desired location. The Fireplace Mantel
should not be positioned in an area exposed
to direct sunlight.
WALL ANCHOR
SAFETY CABLE
The use of WALL ANCHOR SAFETY CABLE
is highly recommended in order to reduce
the risk of the fireplace being tipped over
accidentally. WARNING: This CABLE may
reduce possible risk of injury if the fireplace
is improperly handled, but is not a substi-
tute for proper adult supervision. Children
should not be left unattended near any
heater.
1. Drill a 5/16” (8mm) hole in the wall. Insert
the PLASTIC WALL ANCHOR into the hole
and gently tap until the flange on the anchor
is against the wall surface.
2. Position the back edge of the mantle close
to the wall.
3. Attach the SAFETY CABLE to the mantle
using the SCREW FOR MANTLE. See fig. I
A S S E M B LY I N S T R U C T I O N S
