F E AT U R E S - O P E R AT I O N S
ASSEMBLY INSTRUCTIONS
NOTE:
MAKE SURE YOU REMOVE ALL CONTENTS OF THE
PACKAGE. PLEASE CHECK PACKAGING MATERIALS FOR
PARTS THAT COULD BE REQUIRED TO OPERATE YOUR FAN.
Tools required: Phillips head screw driver (not
included)
Assembly time: 5–10 minutes
1. Insert the lower end of the outer pole through the
hole in the center of base and twist clockwise into
position.
2. Insert the threaded end of the T-shaped locking lever
into the hole of the washer and through the base.
3. Turn the T-shaped locking lever clockwise to securely
attach the pole to the base.
4. Set the base on the floor.
5. Loosen fan post screw and insert the motor housing
over top of extension pole. Tighten fan post screw.
6. Line up the slots of the rear grill with the notches on
the motor housing assembly.
7. Secure rear grill to motor housing assembly with rear
grill mounting nut. Turn clockwise to tighten.
8. Slide blade over motor shaft.
9. Secure fan blade to motor shaft with the blade cap.
Turn counter-clockwise to tighten.
10. Remove the grill screw and nut located on the bottom
of the grill.
11. Slide the front grill over the rear grill.
12. Replace grill screw and nut and tighten with screw
driver.
13. Attach the misting hose clip onto the outer pole (see
Figure 1).
OPERATING INSTRUCTIONS
1. Set the fan on a dry and level surface.
2. Plug the cord into a standard 120 volt AC outlet.
3. The fan controls are located on the back of the Motor
Housing. Select Fan Speed =
0
- Off,
3
- High,
2
- Medium,
1
- Low.
4. Push, Pull Oscillation Knob (
) = Oscillation
On, Off.
MISTING FAN ASSEMBLY INSTRUCTIONS
1. Turn the Fan Speed Knob to the (
0
) position.
2. Attach the end of the Misting Hose Connector to a
standard garden hose and turn on the water. Turn the
switch on the connector to ON position (see figure 2).
3. Turn the Adjustable Mist Knob (see Figure 3) on front
grill to open the desired number of nozzles for
misting (2-3-1).
4. Turn the fan on and enjoy.
ADJUSTMENT INSTRUCTIONS
Tilt Adjustment
Follow these instructions to tilt the fan head for upward
angle air movement.
STEP 1: To change the tilting angle of the fan head;
simply loosen the tilt adjustment knob.
STEP 2: Move the fan head to the desired angle, and
firmly tighten the knob to lock in place.
Height Adjustment
Follow these instructions to adjust the height of the fan.
STEP 1: Turn the height adjustment collar counter-
clockwise to loosen pole.
STEP 2: Adjust the extension pole to the desired height,
and firmly tighten the height adjustment collar in
a clockwise direction.
