Holman WS5052B, Instruction Manual, Page: 9 / 20

7
Initial Operation -
Outdoor Sensor & Indoor Sensor
Programming - Manual Time Setup
Outdoor Sensor
• Please install batteries in the Outdoor Sensor first.
• Open the battery compartment located on the rear side of the device.
Place the batteries in the battery compartment. Observe the shown polarity.
• Please place in a sheltered position outside where it will not get wet or weathered.
Indoor Unit
• Open the battery compartment located on the rear side of the device.
Place the batteries in the battery compartment. Observe the shown polarity.
• The altitude will be flashing, use “+“ or “-“ to set the altitude of your position, then press
“HISTORY” , Weather symbol flashing, use “+“ or “-“ to choose the weather.
• The station is now connecting to the outdoor sensor. This process takes about 3 minutes.
Then the display shows the outdoor temperature and humidity, in case of failure of reception,
press “CHANNEL“ for more than 3 seconds to receive again.
• The flashing Radio controlled symbol will disappear when connected.
Manual Time Set-up
• Press and hold “MODE“ for 3 seconds.
• The display for the 12/24 is flashing. Use “+ “ and “-“ to select. Press “MODE “ to confirm.
• The display for the hour is flashing. Use “+ “ and “-“ select the hour. Press “MODE “ to confirm.
• The display for the minutes is flashing. Use “+ “ and “-“ to select the minutes. Press “MODE “ to confirm.
• The display for the year is flashing. Use “+“ and “-“ to select the year. Press “MODE “ to confirm.
WS5052B Weather Alarm Clock.indd 9 24/07/13 8:22 PM