Holman WS5019, Instruction Manual

Page: 13 / 24

11
Programming - Snooze / 12-24Hr / ºC-ºF Programming - Max/Min Indoor/Outdoor Temp
Snooze function - To activate the snooze function, follow the steps below
• Press the key “ SNOOZE/LIGHT“ , while the alarm sounds, to activate the snooze function.
• If the snooze function is activated, snooze symbol is flashing.
• The alarm will repeat after 5 minutes.
• The snooze function can be stopped by pressing any key.
12/24 hours mode
The time display can be in 12 hour (AM/PM) or 24 hour mode.
°C/°F temperature display
The temperature display can be in °C or °F. Press the key “-“ to switch between the mode.
Press + for displaying of indoor/outdoor max/min. of temperature and humidity Temperature alert set up.
• Press
“CHANNEL” to select the channel (ch1,ch2,ch3) if more than one outdoor sensor are within reach.
• Press and hold the key - , in the area of outdoor, select ON/OFF when flashing.
• Press “MODE” , the upper limit temperature is flashing, use + or – to set the maximum alert temperature.
• Press ”MODE” , the lower limit temperature is flashing, use + or – to set the minimum alert temperature.
• When the alert is activated, the alert symbol will be shown.
Temperature alert on/off
Press and hold the “–” key to set the temperature alert on or off.
• Alert on: Temperature alert symbol shown in display.
• Alert off: Temperature alert symbol goes out.
WS5019 Weather Forecaster.indd 13 25/07/13 10:24 AM