PAGE 5
OPERATOR'S MANUAL
HOLMAN CONVEYOR BAKERS
MODEL MM14
CLEANING PROCEDURES CONT.
E. Check Air Intake area for dust and grease. To clean, remove the Control Box Cover and wipe with a
dry cloth. Do not spray cleaning fluids into the Air Intake. This may result in component failure.
F. Re-assemble unit and check to be sure it is operating properly. Contact the Holman Cooking
Equipment Factory Service Team if assistance is required.
TROUBLESHOOTING GUIDE
A. UNIT WILL NOT HEAT, CONVEYOR BELT WILL NOT TURN.
1. Be sure main Circuit Breaker is switched to the ON position and there is power at the outlet.
2. Check to see that the unit is connected to power and Master On/Off is switched to the ON
position.
3. Be sure HEAT LIMIT SWITCH is pushed in (see below).
CUTAWAY VIEW OF CONTROL BOX WITHOUT
CONTROL BOX COVER.
HEAT LIMIT SWITCH LOCATED ON FRONT OF CONTROL BO
BENEATH FRONT EXTENSION.
B. UNIT WILL NOT HEAT, CONVEYOR TURNS.
1. Check to see if the Master On/Off Switch is in the on position.
2. Press Heat Limit Switch, located on the front section of the control box as shown above. If this
reactivates the Heater Tubes, see section C page 6.
3. Contact the Holman Cooking Equipment Factory Service Team if assistance is required.
TROUBLESHOOTING GUIDE CONT. ON PAGE 6
REVISED 7/9/01 MJC