background image

ELECTRICAL CONNECTION

Before making any electrical connection to this unit, 

check that the power supply is adequate for the voltage, 

amperage and requirements stated on the rating plate.   

A wiring diagram is included in the Installation & 

Operations manual, which can be downloaded at 

 

www.star-mfg.com/scripts/manuals.aspx

.

Disconnect the unit from the power source before installing or 

removing any parts.
Be absolutely sure that the ground connection for the receptacle is 

properly wired.  Do not connect equipment to power without proper 

ground connections.  Improper grounding may result in personal 

injury or fatality.

DO NOT CUT OR REMOVE THIS PLUG OR 

GROUNDING PRONG FROM THE PLUG.

CONNECT/PLUG UNIT INTO DEDICATED 

A.C. LINE ONLY SPECIFIED ON THE DATA 

PLATE OF THE UNIT.

CERTAIN SURFACES ARE EXTREMELY HOT 

DURING OPERATION AND CARE SHOULD 

BE TAKEN WHILE USING THIS UNIT.

DO NOT IMMERSE OR LET THE UNIT STAND 

IN WATER.

DO NOT HOSE DOWN THE UNIT OR THE 

TABLE/COUNTER IF THE UNIT IS ON THE 

TABLE/COUNTER.

KEEP AWAY FROM RUNNING WATER. 

IRCS2-SBW INSTALLATION REQUIREMENTS

1.  Space: 16”x24”x18”  

(width x depth x height) 

2.  Electricity: 208/240 Volts, 

30 Amps, NEMA 6-30R 

Recepticale

IRCS2-NW INSTALLATION REQUIREMENTS

1.  Space: 10” x 29” x 17.5” 

(width x depth x height) 

2.  Electricity: 208/240 Volts, 

12 Amps, NEMA 6-20R 

Recepticale

NOTE: Ensure to clean the toaster properly before 

using it for the first time.  Refer to the Cleaning 

Procedure document for cleaning instructions.

CAUTION

WARNING

The Holman IRCS conveyor toaster  

comes with pre-programmed factory 

default settings for ALL MENU 

BUTTONS

.

Factory default settings are as follow:

POWER SAVER SWITCH

There are three Power Saver modes:

ON:  

Unit is in pre-programmed power saving setting.

OFF:  

Power Saver mode is turned off.

AUTO ON: 

Power Saver turns on when there has been no activity 

for a programmed length of time.

The operator may adjust the level of power reduction for the saver 

mode. 

(Note: conveyor may move slowly when in saver mode.)

Two buttons (+) and (-) are used when increasing or decreasing the 

value of each programmable setting.
A red LED light located at the lower portion of the control panel label 

will indicate if the value for top heat, bottom heat or conveyor speed 

is being adjusted.

NEMA L6-30R

WARNING

WARNING

WARNING

WARNING

NEMA L6-20R

IRCS2-SBW DEFAULT SETTINGS

Menu 

Buttons

Top 

Heat

Bottom 

Heat

Conveyor 

Speed

T1

3.2

4.3

1

T2
T3
T4
T5
T6

IRCS2-NW DEFAULT SETTINGS

Menu 

Buttons

Top 

Heat

Bottom 

Heat

Conveyor 

Speed

T1

4.0

5.4

1

T2
T3
T4
T5
T6

ELECTRONIC

RADIANT-IMPINGEMENT SYSTEM

TOP HEAT

BOTTOM HEAT
CONVEYOR SPEED

SAVER

ON

OFF

T3

T4

T1

T2

T5

T6

IL2711

Summary of Contents for IRCS2-NW













Reviews: