7
QCSe & RCSe OPERATION
The Holman QCSe conveyor toaster comes with pre-programmed factory default settings for TOAST,
MUFFINS, and BAGELS. The operator may change these setting at any time. A button labeled
OTHER is provided to allow the operator to program settings for additional product(s).
Press TOAST and TST will appear in the display.
Press MUFFIN and MUF will appear in the display.
Press BAGEL and BGL will appear in the display.
Press OTHER and OTH will appear in the display.
LIGHT
and
DARK
buttons are used to change the conveyor
speeds when in toast, muffin, or bagel modes.
Pressing the
(LIGHT)
button once will increase the conveyor
speed by 15%. Pressing twice
(XLIGHT)
will increase the
conveyor speed by 30%.
Pressing the
(DARK)
button once will decrease the conveyor
speed by 10%. Pressing twice
(XDARK)
will decrease the
conveyor speed by 20%.
Note: After 60 seconds the conveyor speed will return to the pre-
programmed setting.
The factory default settings are as follow:
TOAST AND OTHER
BAGEL:
TOP HEAT
9
TOP HEAT
9
BOTTOM HEAT 9
BOTTOM HEAT
9
CONVEYOR
59
CONVEYOR
24
OTHER:
POWER SAVER:
TOP HEAT
9
TIME (minutes)
60
BOTTOM HEAT 9
HEAT
5
CONVEYOR
59
The QCSe toaster is equipped with a Power Saver Switch
(SAVER) that reduces the power used by the toaster after a pre-
programmed period of time. This Power Saver Switch has three
modes:
ON:
Unit is in pre-programmed power saving setting.
OFF:
Power Saver mode is turned off.
AUTO ON:
Power Saver turns on when there has been no
activity for a programmed length of time.
The operator may adjust the level of power reduction for the saver
mode. (Note: conveyor may move slowly when in saver mode.)
Two buttons (+) and (-) are used when increasing or decreasing
the value of each programmable setting.
A red LED light located at the lower portion of the control panel
label will indicate if the value for top heat, bottom heat or conveyor
speed is being adjusted.
QCS
®
e