Install Wheel Holders:
Rotate and remove L pins from holes
A
. Rotate wheel tubes to a horizontal
position, then replace L pins into holes
B
as indicated.
Slide wheel Holders
E
and
F
onto
wheel tubes as indicated.
2
Fig. 2a
Fig. 2b
Fig. 2c
After installing wheel holders, install
the “stop” screws into the bottom of
the wheel tubes as indicated in Figure
2c. Use Phillips screwdriver.
Installing extension assembly for 4
bike capacity
Note: Remove front square reflector cap.
You will need a Phillips head screwdriver
(screw located on bottom
of tube. (Please put it someplace where
you won’t lose it!)
Slide extension assembly all the way into
base assembly per
Fig. 1a
.
Insert the pin through the holes. Be sure
that the pin passes through the welded
loop on the end the bolt attached to the
lever N.
Then install
R
clip through the pin.
Tighten the lever until good and snug. Do
not over torque!
Fig. 1a
Fig. 1b
Fig. 1c