3
Figure 3
NOTE:
A spark plug wire retainer is supplied to secure the plug wires in place. Align the mounting bosses and use the
supplied 1.5” self-tapping Phillips screws to hold the retainer in place.
8. Next, locate the wiring harness supplied with the distributor, plug the 2 pin connector from the distributor harness into
the 2 pin connector on the Sniper EFI Main Harness (7 pin Connector). These connectors are keyed, however the
Purple and Green wires should plug into each other (
Figure 4
).
Figure 4
9. Now, plug the 3 pin distributor connector into the 3 pin connector on the provided wiring harness (
Figure 5
).
Figure 5
10. Next, terminate the Pink switched 12v wire on the 3 pin distributor wiring harness, to the clean switched 12v ignition
source that you labeled earlier.
