EN 14
15 EN
Brush Head Maintenance
—— Clean the Brush roller
Brush Head Maintenance
—— Clear Obstacles
OPEN
CLOSE
1
4
2
5
3
6
1
4
2
3
If you use a vacuum cleaner to clean fine dust or mainly use the boost
mode, the filter unit may require more frequent cleaning.
Do not put any accessories of this product in the dishwasher and wash-
ing machine or dry it in a tumble dryer, oven, microwave or open flame.
Before replacing or cleaning the brush roller, make sure that the brush
head and the aluminum tube are separated and the vacuum cleaner
has been powered off.
When disassembling or replacing the electric brush roller, do not press
the switch button until the brush head is reassembled.
Let the brush head stand sideways, and make the roller brush
release button upwards, then insert a coin in the slot according to the
instructions, press and rotate it counterclockwise, or use the thumb
to rotate it counterclockwise.
Push the brush roller gently, and slide the brush roller out of the
brush head, and remove the brush roller for cleaning.
Place the brush roller under running water and gently rub it to remove
any lint or dust.
The floor brush of this product is equipped with two washable brush
rollers. Regularly clean the brush roller according to the instructions to
ensure performance:
Brush Head Maintenance
—— Clean the Brush roller
foam with cold water, gently squeeze out the dirt from the sponge;
Continue to rinse until the water is clean.
Take out the filter holder according to Fig. 2.
Rinse the filter holder under clear water until it is cleaned.
Place the filter in a well ventilated and dry environment for at least 24
hours to allow it to dry thoroughly.
Check that the filter unit is completely dry.
To reinstall the filter unit, place the foam part back into the filter unit
and rotate the unit to the locked state as indicated.
Summary of Contents for HM322A
Page 6: ......
