4
ASSEMBLY INSTRUCTIONS
1. Place all the parts on the floor.
Insert the three metal rods of the bottom trunk
(A) into the corresponding tubes on the support
stand (E).
Insert the two metal rods at the bottom of the middle
trunk (B) into the corresponding holes on top of the
bottom trunk (A).
Insert the two metal rods at the bottom of the upper
trunk (C) into the corresponding holes on top of the
middle trunk (B).
2. Insert a plastic tie (AA) through the pair of matching
rings on each side of the lower and middle trunk and
fasten them together.
Insert a plastic tie (AA) through the pair of matching
rings on each side of the middle and upper trunk and
fasten them together.
Insert the metal rod of each palm leave (D) into the
corresponding hole on top of the trunk assembly. The
three smaller leaves should be attached to the centre
of the tree and the five bigger leaves around the sides.
3. Make sure the male plug of the lights string of the
palm leaves (D) is connected to the female plug of the
lights string from the trunk assembly.
Carefully wrap the G40 light string (F) evenly onto the
palm leaves (D).
Make sure the male plug of the G40 light string is
connected to the female plug of the lights string
from the palm leaves.
4. Secure the figure to the floor using the ground
stakes (BB) provided.
Plug into a properly grounded receptacle.
4
1
2
3
4
Hardware Used
Plastic Tie x 4
Hardware Used
Ground Stake x 4
