PRO 132T
This document is protected by copyrights.
Copying, using, or distributing without permission of PROMOTECH is prohibited.
8
21.
Do not use near flammable materials or in explosive environments.
22.
Do not use on surfaces that are rough, not flat, not rigid, or have rust, paint,
chips, or dirt.
23.
Do not use if the gibs are adjusted
incorrectly.
24.
Do not use if there is no grease on the gibs.
25.
Do not use the gear switches if the motor is on
.
26.
Use the safety strap to attach the machine to a stable structure. Put the strap
through the hole in the machine body. In the horizontal position, attach the strap
to the carrying handle. Do not put the strap into the buckle from the front.
27.
Use eye and ear protection and protective clothing. Do not use loose clothing.
28.
We do not recommend work on workpieces thinner than 10
mm (0.4″). Th
e
clamping force depends on the workpiece thickness and is much lower for thin
plates.
29.
Each time before you put the machine on the workpiece, rub the workpiece with
coarse-
grained sandpaper. Make sure that the bottom of the base is in full con-
tact with the workpiece.
30.
Do not touch chips or moving parts. Do not let anything catch in moving parts.
31.
After each use, remove chips and coolant from the machine and the tool. Do
not
remove chips with bare hands.
32.
Unplug the power cord before you do maintenance or install/remove parts.
33.
Repair only in a service center appointed by the seller.
34.
If the machine falls, is wet, or has any damage, stop the work and immediately
send the machine to the service center for check and repair.
35.
Do not leave the machine when it operates.
36.
If you are not going to use the machine, remove the tool from the holder. Then,
remove the machine from the work area and keep it in a safe and dry place.
37.
If you are not going to use the machine for an extended period, put anti
-
corrosion
material on the steel parts.
