11
6.2.2. Annular Cutter adjusting
Warning! Edges of cutters are sharp.
Turn the arbor holder to 90° position (see
drawing.)
When placing the cutter inside the arbor, the
fixing screw must be in touch with cylindrical
surface of Weldon shank ( not flat surface) of
the cutter. (Do not tighten the screw). This is
necessary to avoid the cutter changing
position during screw tightening , resulting in
incorrect set up.
The laser radius enables accurate positioning
of the cutter in the arbor ( right drawing) .
Whellhead support (pt 6.1. pos. 9) has got
white line (see drawing). During laser radius
positioning, its light must be always located on
this line. This is the method of basic laser
radius positioning or its new positioning.
