BEFORE PROCEEDING, PLEASE MAKE SURE
YOU HAVE READ THE INTRODUCTION, SYSTEM
ADJUSTMENT, AND MOUNTING SECTIONS
16
REAR SPEAKERS
Step #1: Remove the seat, and both wires (+ and -) from the battery.
Step #2: Remove the outer fairing/headlamp assembly. Refer to a service manual
if you need help with this. Note: A towel on the front fender can help
prevent scratches or “dings” from dropped tools or fasteners etc.
Expletives will also be kept to a minimum.
Step #3: Locate the bag with 3 separate harnesses. It has the amps power
harness (red, black, and orange wires with a 3 pin green plug), input
harness (ending in an 8 pin white plug), and a front out harness (4
pin black plug with blue/black, and brown/black wires). Put the 4
pin black plug from this bag aside. It will not be used in this installa-
tion. Plug the power harness into the amp, and make sure to secure the
screws to prevent the harness from backing out while riding. Plug the
input harness into the amp where it says “Audio Input/Exp. Port”. There
is another harness bag marked “rears”. At one end of that harness is
a black plug with 4 wires and a blue plug with 4 wires. Plug the black
one into “Amplified Output” on the amp.
Step #4a: Mounting the amp For Standards, Street Glide, EG Classic, and Ultra
Classic If this is the only amp in the system, the amplifier gets mounted
to the top of the factory radio using the supplied “hook and loop” ad-
hesive, and must sit so you can read the text on top of the amplifier as
in diagram 1.1 .The amplifier needs to
mount as far back on the radio as pos-
sible so the fairing can go back on. The
minimum distance from the back of the
radio to the most forward edge of the
amplifier is 5/8” (15mm). On pre-2006
model bikes, it is a tight fit--but will go.
2006+ (Advanced Audio) radios have
a “bump” on top of the radio that runs
from front to back down the center of the
radio. Cut the adhesive in half and apply
each piece on either side of this bump.
The amp will then mount flush. Most
adhesives work best at room
temperature or higher. Note: 2006 and
newer Ultras have the CB module on top
of the radio. The amp will adhere on top
of the CB module so it is “half on/half
off this module as shown in Diagram
1.2. The supplied adhesive is plenty
strong for this! The amp can adhere
on top of CB and XM modules without issue.
Diagram 1.1
No CB/XM Module Present
Diagram 1.2
Shown mounted on top
of CB Module
